Installation Guide

Installation
10
Cabinet clearances
Clearance L can have the following values:
• L = 30” (762 mm) min. minimum
clearance between the top of the
cooking surface and the bottom of an
unprotected wood or metal cabinet..
• L = 24" (610 mm) minimum when the
bottom of wood or metal cabinet is
protected by not less than 1/4-inch-
thick flame-retardant millboard covered
with not less than No. 28 MSG sheet
steel, 0.015-inch-thick stainless steel,
0.024-inch-thick aluminum, or 0.020-
inch-thick copper. Clearances from non-
combustible materials are not part of the
ANSI Z21.1 scope and are not certified
by CSA. Clearances of less than 30''
should be approved by the local codes
and/or by the local authority having
jurisdictiont.
1
min. clearance from the sides of range to
side wall or other combustible material;
2
min. cabinet opening width;
3
upper cabinet to countertop;
4
max. upper cabinet depth.
The side cabinet depth (clearance B) must
match the front edge of the range side
panel.
A 36" 914 mm
B 25” 630 mm
C
1
20" 508 mm
G
2
min. 36" min. 914 mm
I
3
18" 457 mm
L see notes below
M
4
13" 330 mm
P
4
13" 330 mm
The distance between the
appliance and the rear wall below
the worktop is zero.
The distance between the
appliance and the side cabinets
below the worktop is zero.
Any opening in the wall behind the
appliance and in the floor under
the appliance shall be sealed.