User manual

Installation
17
EN
7. Use the following distances for the
distance from the side of the appliance
to the bracket holes.
8. After having positioned and leveled the
appliance, move the bracket close to the
rear of the appliance and anchor it to the
floor using the two washers and screws.
A qualified technician must verify the
suitability of the materials in accordance
with the type and condition of the floor.
9. Push the cooker towards the wall, and at
the same time, insert the bracket in the
plate that is fastened to the rear of the
appliance.
10. Check for proper installation and use of
the anti-tip bracket. Carefully tip the
range forward by pulling it from the
back to ensure that the anti-tip bracket
engages the range leg and prevents
tip-over. The range should not move
more than 1” (2.5cm).
WARNING
The rear vent trim has
3
/
16
” (5 mm)
standoffs to keep the appliance slightly
away from the back wall. Do not remove
or tamper with standoffs due to potential
temperature issues.