User manual

Installation
13
EN
The appliance must sit level on the floor to
ensure stability:
• Screw or unscrew the bottom part of the
foot until the appliance is stable and
level on the floor. The adjustment range
of the screw is 1.18“(30 mm).
Assembling the backguard
The backguard must always be positioned
and secured correctly on the appliance.
1. Position the backguard above the top,
taking care to align the holes.
2. Secure the backguard to the top by
tightening screws.
3. Once you have fixed the backguard to
the appliance, you must insert the screws
and spacers provided that are necessary
for the slot-in installation.
1.3 Electrical connection
NOTE: this appliance must only
use the specific leveling legs
provided by the manufacturer.
The backguard provided is an
integral part of the product; it must
be fastened to the appliance prior
to installation.
WARNING
Electrical shock hazard
•This appliance is
equipped with a three-
prong grounding plug for
your protection against
electric shock and should
be plugged directly into a properly
grounded receptacle. Do not cut or
remove the grounding prong from this
plug.
• The grounding prong must be plugged
into a matching grounding type
receptacle and connected to a correctly
polarized 120-Volt circuit. If there is any
doubt as to whether the wall receptacle
is properly grounded, have it checked
by a qualified electrician.
• Failure to do any of the above could
result in a fire, personal injury or
electrical shock.