User manual

Installation
10
• Connect to a 20A fuse or circuit breaker.
Connect to copper wire, or, if
connection is made to aluminum house
wiring, use UL-listed or CSA-approved
connectors approved for joining
aluminum and copper wiring.
Fixed connection
Fit the power line with an multi-pole circuit
breaker in compliance with installation
regulations.
The circuit breaker should be located near
the appliance and in an easily reachable
position.
1.4 Grounding Instructions
This appliance must be connected to a
grounded, metallic, permanent wiring
system, or an equipment grounding
conductor should be run with the circuit
conductors and connected to the
equipment grounding terminal or lead on
the appliance.
Warning! IMPROPER USE OF THE
GROUNDING CAN RESULT IN A RISK
OF ELECTRICAL SHOCK.
Please refer to the Installation Instructions for
further information.
Cable replacement
1. Unscrew the rear casing screws and
remove the casing to access the terminal
board.
2. Replace the cable.
3. Make sure that the cables (for the oven
and/or cooktop) follow the best route in
order to avoid any contact with the
appliance.
NOTE: Both leads coming out of
the appliance must be connected
according to the diagrams shown
in figures.
Power voltage
Danger of electrocution
• Disconnect the main power supply.