User manual

EN
Instructions for the User
26
When the display shows “0.5L”, remove the water tank.
Pour 0,5 litres of an adequate descaling solution into the water tank and
put the water tank back (see 11.2).
Press PT2 to start the Descale cycle that takes about 30 minutes.
When the display shows “1.0L” flashing and the oven emits a beep,
remove and empty the water tank.
Fill the water tank with 1,0 litres of cold water and put the water tank back.
Press PT2 to start the first rinsing cycle.
When the display again shows “1.0L” flashing and the oven emits a new
beep, remove and empty the water tank.
Fill the water tank with 1,0 litres of cold water and put the water tank back.
Press PT2 to start the second rinsing cycle.
When the rinsing cycle has finished the display shows “End”.
Remove, empty and dry the water tank.
8.3.5 Changing the water hardness level
With the oven in OFF status (see point “Operating settings”) keep PT1
pressed until the message OFF SHO appears on DSP1. Now press PT1
until the message “MED DUR” appears on DPS1 and DSP2.
Turn PT1 to the right or left to change the hardness level. Available
options are HARD, MED and SOFT.
After setting the parameter required, press PT2 to return the oven to the
initial standby status.