User manual

Instructions for the User

After setting the parameter required, press PT2 to return the oven to the

initial standby status.

8.3.2 Child safety lock-out function

With the oven in OFF status (see point “Operating settings”) keep PT1

pressed until the message OFF SHO appears on DSP1. Now press PT1

once and the message “OFF BLOC” appears on DPS1.

Turn PT1 to the right or left to activate (ON BLOC) or deactivate (OFF

BLOC) this function, which locks out all the functions and knobs after 3

minutes of operation without any command from the user (when this

system is active, the symbol appears on DPS2).

After setting the parameter required, press PT2 to return the oven to the

initial standby status.

To exit the lockout status temporarily to modify a cooking program or

select a different function, keep PT1 pressed until the symbol

disappears from DSP2. The required changes can now be made, and 2

minutes after the last setting is made the lockout will come into operation

again.

To deactivate the lockout permanently, access the secondary menu and

switch the function off as described in this section.

8.3.3 Power selection function

This function allows the oven operation if there are limitations in the mains

power (e.g. 3 kW for Italian market). The cooking results will not be

affected but the cooking duration will be increased on some functions that

activated more than one heating element.

With the oven in OFF status (see point “Operating settings”) keep PT1

pressed until the message OFF SHO appears on DSP1. Now press PT1

once again and the message “OFF 3000” will appear on DPS1.

Turn PT1 to the right or left to activate (ON 3000) or deactivate (OFF

3000) this function, which limits the oven's maximum power absorption, in

any function, to 3000 W.

After setting the parameter required, press PT2 to return the oven to the

initial standby status.

8.3.4 Descale function

Warning: For safety reasons, the descaling process cannot be

interrupted and it takes about 45 minutes.

The appliance can be descaled with the appliance door open or closed.

To run a descaling cycle proceed as follows:

With the oven in OFF status (see point “Operating settings”) keep PT1

pressed until the message OFF SHO appears on DSP1. Now press PT1

(several times) until the message “ENTR CAL” appears on DPS1 and

DSP2.

Turn PT1 to the right and press PT2 at the same time to activate the

descale program . When this function is active, the symbol appears on

DPS2.