Instruction manual

Installation
91
EN
5.2 Section cut from the countertop
To prevent leakage of liquid between the
frame of the hob and the countertop, place
the adhesive seal provided along the entire
outer edge of the hob before assembly.
Flush mounted installation
Make a hole in the countertop of the unit
according to the dimensions shown in the
figure (mm).
After laying the adhesive seal (A) on the
glass surface and after positioning and
securing the hob, fill the edges with
insulating silicone (B) and wipe away any
excess.
In the event the hob needs to be removed,
cut the silicone using a cutter before
attempting to remove it (C).
The following operation requires
building and/or carpentry work
and must therefore be carried out
by a competent tradesman.
Installation can be carried out on
various materials such as masonry,
metal, solid wood or plastic
laminated wood as long as they
are heat resistant (>90°C).
A B C D E
min.
200
min.
460
min.
750
40-60
min.
65
Do not use silicone to secure the
hob. This would make it impossible
to remove the hob, if necessary,
without damaging it.
L X Y Z
650 560 - 564 482 - 486 50
750 720 - 724 482 - 486 50
900 844 - 848 482 - 486 46