INSTRUCTION MANUAL DISHWASHER
Contents 1. Safety and operating instructions __________________________ 28 2. Installation and hook-up _________________________________ 30 2.1 Water supply connection _____________________________________________________ 30 2.2 Electrical connection ________________________________________________________ 31 3. Description of the controls _______________________________ 32 3.1 Front panel ________________________________________________________________ 32 3.
Safety instructions 1. Safety and operating instructions THIS MANUAL FORMS AN INTEGRAL PART OF THE APPLIANCE: IT MUST ALWAYS BE KEPT INTACT TOGETHER WITH THE DISHWASHER. BEFORE USING THE APPLIANCE, CAREFULLY READ ALL THE INSTRUCTIONS CONTAINED IN THIS MANUAL. INSTALLATION MUST BE PERFORMED BY A QUALIFIED TECHNICIAN, IN COMPLIANCE WITH THE REGULATIONS IN FORCE.
Safety instructions DO NOT USE APPLIANCES WHICH HAVE BEEN DAMAGED DURING TRANSIT! IF IN DOUBT, CONSULT YOUR DEALER. THE APPLIANCE MUST BE INSTALLED AND CONNECTED IN ACCORDANCE WITH THE INSTRUCTIONS PROVIDED BY THE MANUFACTURER OR BY A QUALIFIED TECHNICIAN. THE APPLIANCE IS INTENDED FOR USE BY ADULTS. DO NOT ALLOW CHILDREN TO COME NEAR OR PLAY WITH THE DISHWASHER. KEEP CHILDREN AWAY FROM DETERGENTS AND FROM THE OPEN DISHWASHER DOOR. THE PACKAGING MATERIALS (PLASTIC BAGS, POLYSTYRENE, METAL BARS, ETC.
Installation instructions 2. Installation and hook-up Remove the polystyrene basket retainers. Position the appliance in the desired place of installation. The back or sides of the dishwasher may be placed up against walls or other furniture units. If the dishwasher is installed near a heat source, fit the special insulating panel to prevent overheating and malfunction of the appliance.
Installation instructions DRAIN CONNECTION Insert the dishwasher’s drain hose into a drain pipe having a diameter of at least 4 cm, or alternatively, place it inside the kitchen sink using the plastic support provided, taking care not to crush or excessively bend the hose. It is important to prevent the hose from coming loose and falling. For this purpose, the plastic support is equipped with a hole for tying it to the wall or water tap.
User instructions 3. Description of the controls 3.1 Front panel All the dishwasher's controls and indicators are located on the front panel. 1 WASHING PROGRAM SELECTOR 2 ON/OFF AND DELAYED START SELECTOR 3 START/STOP BUTTON 4 ½ LOAD WASH BUTTON 5 ECO DRYING CYCLE BUTTON (certain models only) 6 INFORMATION DISPLAY 7 ½ LOAD WASH LIGHT 8 ECO DRYING CYCLE LIGHT (certain models only) 9 SALT WARNING LIGHT 10 RINSE AID WARNING LIGHT 11 RECESSED DOOR HANDLE 3.
User instructions PROGRAM SEQUENCE PROGRAM PROGRAM SELECTOR ECO DRYING (OPTIONAL) INFORMATION DISPLAY SUPER P8 ECO P7 (*) BIO EN 50242 P6 (3) EVER YDAY P5 NORMAL P4 QUICK _ (4) DELICATE SOAK (4) _ DISHE TYPE AND DEGREE OF SOILING DURATION CONSUMPTION QUANTITY DET ERGENT PRE-WASH WASH COLD RINSE HOT RINSE DRYING MINUTES (2) WATER LITRES (1) POWER Kw h (2) HEAVIL Y SOILED DISHES, POTS AND PANS WITH DRIED-ON RESIDUE 10 - 25 HOT 70°C 2 YES YES 135' 17 1,45 NORMALLY SO
User instructions POWER SWITCH-ON In order to switch on the appliance just turn the ON/OFF selector (2) till it corresponds with the letter I. TABLE FOR CERTIFICATION BODIES Reference standard Reference program Load Type of detergent Amount of detergent Rinse aid setting EN 50242 (*) Selector on P6 + ECO DRYING 14 place-settings B 35 g Depending on the model 3/4 or 4/6 EN 50242 DISABLING THE END OF CYCLE ACOUSTIC DEVICE It is possible to disable the sounding of the start/end of cycle acoustic device.
User instructions 3.3 Washing programs The dishwasher is equipped with a control panel and an INFORMATION DISPLAY, described in chapter "3. Description of the controls", from which it is possible to carry out all the power switchon, switch-off and programming operations. Before starting a washing program make sure that: The water supply tap is open. • The correct amount of detergent has been added to the dispenser. • The baskets have been correctly loaded.
User instructions DELAYED START The start of the program can be delayed by 1, 2, 4, 6, 8 or 12 hours. In this way, it is possible to run the dishwasher when most convenient. Turn the DELAYED START selector (2) until it is aligned with the number of hours of delay required before the program start. This information automatically appears on the INFORMATION DISPLAY (6) as well.
User instructions If it is necessary to open dishwasher door during the washing cycle, there will be a 1-minute delay before the program can be resumed. After correctly closing the door, press the START/STOP (3) button again. This operation may negatively affective the progress of the washing cycle. END OF CYCLE The end of the washing cycle is signalled by a brief sounding of an acoustic device and by the blinking of the selected program on the INFORMATION DISPLAY (6).
User instructions 4. Operating instructions Once the dishwasher has been correctly installed, prepare for use as follows: Adjust the water softening system; • Add the regenerating salt; • Add the rinse aid and detergent. • 4.1 Using the water softening system The amount of scale contained in the water (water hardness index) can cause whitish staining on the dry dishes, which tend to become dull over time.
User instructions ADJUSTING THE WATER SOFTENING SYSTEM The dishwasher is equipped with an electronic device for adjusting the water softening setting according to the hardness of the water. To adjust the water softening setting, proceed as follows: • Press down the HALF LOAD (4) button for a few seconds until the bS symbol appears on the INFORMATION DISPLAY (6). • Press the START/STOP (3) button to access the water softening settings (the current setting appears on the information display).
User instructions 4.2 Using the rinse aid and detergent dispensers The detergent and rinse aid dispensers are situated on the inner part of the door: the detergent dispenser is on the left, and the rinse aid dispenser is on the right. With the exception of the SOAK program, before every washing cycle it is necessary to add the required amount of detergent to the detergent dispenser. The rinse aid, on the other hand, should only be added as required.
User instructions ADDING THE DETERGENT To open the detergent dispenser cap, lightly press the button P. Add the detergent and close the cap carefully. During the washing cycle, the dispenser will be opened automatically. • • • • • • • • When a SUPER program is selected, in addition to the normal dose of detergent, it is necessary to add an additional amount inside compartment G or H. Use only detergents specially formulated for dishwashers.
User instructions 4.3 General warnings and recommendations Before using the dishwasher for the first time, it is advisable to read the following recommendations concerning dish types to be washed and their loading. There are generally no constraints on the washing of domestic dishes, but in certain cases it is necessary to take their characteristics into account. Before loading the dishes into the baskets it is necessary to: remove coarse food remains: e.g. bones, fish-bones, etc.
User instructions 4.4 Using the baskets The dishwasher has a capacity of 14 place-settings, including serving dishes. LOWER BASKET The lower basket receives the full force of the lower spray arm, and should therefore be used for the “toughest” items with a heavier degree of soiling. All types and combinations of loads are permitted, provided that the dishes, pots and pans are arranged with all the soiled surfaces exposed to the water jets coming from the bottom.
User instructions CUTLERY BASKET The cutlery should be arranged in an orderly manner inside the basket, with the handles pointing downwards. Take care during loading to avoid injury from the knife blades. The basket is suitable for all types of cutlery, except those long enough to interfere with the upper spray arm. Ladles, wooden spoons and cooking knives can be placed in the upper basket, making sure that the knife blades do not protrude from the basket.
User instructions LOADING THE UPPER BASKET Load plates facing forward; cups, bowls etc. must always be facing downwards. The left-hand side of the basket can be loaded with two layers of cups and glasses. The centre can be filled with plates and side-plates, fitted upright into the supports provided. Loading examples: ADJUSTING THE UPPER BASKET The upper basket can be adjusted in two positions, according to the user’s needs and according to the height of the dishes in the lower basket.
User instructions 5. Cleaning and maintenance Before carrying out any work, always disconnect the appliance from the electrical power supply. 5.1 General warnings and recommendations Avoid the use of acidic or abrasive detergents. Clean the outer surfaces and door-lining of the dishwasher regularly using a soft cloth moistened with water or with a normal detergent suitable for painted surfaces. Clean the door gaskets with a damp sponge.
User instructions CLEANING THE FILTER UNIT It is advisable to periodically inspect the centre filter C and, if necessary, to clean it. To remove • the filter, grip the tabs, turn them anticlockwise and lift upwards; push the centre filter D from the underside to remove it from the micro-filter: • separate the two parts which make up the plastic filter by pressing the body of the filter in the • zone shown by the arrows; remove the centre filter by lifting it upwards.
User instructions TROUBLESHOOTING MINOR PROBLEMS In some cases it is possible to remedy minor problems by referring to the following instructions: If the program fails to start, check that: • • • • the dishwasher is connected to the electrical power supply; there is no power failure; the water tap is open; the dishwasher door is properly closed.
User instructions 6. Troubleshooting The dishwasher is equipped with a self-diagnostics system that is capable of detecting and signalling a number of possible faults. In the event of a fault or malfunction, before calling the After-sales service centre, we suggest that you first consult the troubleshooting guide below.
User instructions TECHNICAL DATA Width Depth measured flush with the outer edge of the control panel Height Capacity Water supply pressure Electrical characteristics 50 597 ÷ 599 mm Free standing: 600 mm from 850 mm to 870 mm 14 Standard place settings min. 50 – max. 900 KPa (min. 0.5 – max.
Solosualcunimodelli Certainmodelsonly Seulementsurcertainsmodèles nurbeieinigeModellen Sóloenalgunosmodelos alleenindienvantoepassing
SUPERFICIEINTERNA SURFACEINTERNE INNERSURFACE INNENFLACHE LATOSUPERIORE BORDSUPERIEURE UPPEREDGE OBERKANTE
Solosualcunimodelli-Certainmodelsonly Seulementsurcertainsmodèles-nurbeieinigeModellen Sóloenalgunosmodelos-alleenindienvantoepassing Regolazionevitetensionemolle(12)-Coperturafotocontappoindotazione(13) DoorspringAdjustementdevice(12)-Coveringofholeusingcapprovided(13) Réglagedesressortsdelaporte(12)-Couverturedutrouaveclebouchonfourni(13) VorrichtungfürdieEinstellungderSpannungderTürfedem(12)AbdeckendesLochsmitdemmitgeliefertenStopfen(13) 10 1 8 9 11 13
