User manual

Installation
48
opens on bottom
opens on rear
Over empty kitchen unit or drawers
If there are other pieces of furniture (lateral
walls, drawers, etc.), dishwashers or fridges
under the hob, a double-layer wooden
base must be installed at
least 10 mm from the bottom of the hob to
avoid any accidental contact. It must only
be possible to remove the double-layer
base using suitable equipment.
5.4 Gas connection
General information
Connection to the gas supply network can
be made using a copper hose or a
continuous wall steel hose with tapered
connection in compliance with the
provisions established by the applicable
standard.
For supplying it with other types of gas, see
chapter “5.5 Adaptation to different types
of gas”. The gas inlet connection is
threaded ½” external gas (ISO 228-1).
Failure to install the double-layer
wooden base exposes the user to
possible accidental contact with
sharp or hot parts.
Gas leak
Danger of explosion
• After carrying out any operation, check that
the tightening torque of gas connections is
between 10 Nm and 15 Nm.
• If required, use a pressure regulator that
complies with current regulations.
• At the end of the installation, check for
any leaks with a soapy solution, never
with a flame.
• The hoses should not come into contact
with moving parts and should not be
crushed in any way.
• The adjustment conditions for this
appliance are shown on the gas setting
label.