Instruction manual 4
Table Of Contents
- Important safety instructions
- 2. COOKTOP MEASUREMENTS
- 3. POSITIONING THE COOKTOP AND LOCATION REQUIREMENTS
- 1 Remove all packaging parts (e.g. crate, carton, polystyrene and metal hooks). Do not eliminate this manual as it is an integral part of the appliance and it should be kept handy for easy reference whenever needed.
- 2 Temporarily remove all removable parts from the cooktop that could fall and cause personal injury or damage to objects (burners, crowns and flame caps) during the attachment procedures These parts must be refitted before using the appliance.
- 3.1 Gas supply requirements
- 3.2 Electrical requirements
- 3.2.1 Recommended Grounding Method
- 4. INSTALLING THE COOKTOP
- 5. CHECKING OPERATION
- 1 a spark must light on all burners when the knobs on the top are pressed
- 2 when each knob on the cooktop is pressed and turned to the low flame symbol ( ), the entire crown should light.
- 3 lf burners do not light properly, turn the control knob to the "OFF" position O . Check that burner caps and crowns are in the proper position. Check that the power supply cord is plugged in and that circuit breaker or house fuse has not blown. Che...
- 6. WIRING DIAGRAMS
Instructions for the Installer
13
5)
Always use pipe-joint compound made for use with NATURAL
GAS and L.P. GAS between pressure regulator D and adaptator C
and between pressure regulator D and pipe E. If flexible metal
conductor is used, be certain tubing is not kinked.
Use only pipes (E) conforming to standard regulations in force,
inserting gasket B (supplied) between fitting A adaptator C.
The adaptor C must be fitted on the gas connection A before fixing
the hob.
Always place a suitable sealing medium (such as Teflon tape)
between pressure regulator D and adaptator C and between
pressure regulator D and pipe E.
6)
Before turning on the burners, make sure that the flame-spreader
crowns and respective caps are properly fitted in their housings.
Ensure the flame-spreader holes A are aligned with the ignition
plugs and the thermocouples.
7)
Plug power supply cord into grounded outlet.