Instruction manual 4
Table Of Contents
- Important safety instructions
- 2. COOKTOP MEASUREMENTS
- 3. POSITIONING THE COOKTOP AND LOCATION REQUIREMENTS
- 1 Remove all packaging parts (e.g. crate, carton, polystyrene and metal hooks). Do not eliminate this manual as it is an integral part of the appliance and it should be kept handy for easy reference whenever needed.
- 2 Temporarily remove all removable parts from the cooktop that could fall and cause personal injury or damage to objects (burners, crowns and flame caps) during the attachment procedures These parts must be refitted before using the appliance.
- 3.1 Gas supply requirements
- 3.2 Electrical requirements
- 3.2.1 Recommended Grounding Method
- 4. INSTALLING THE COOKTOP
- 5. CHECKING OPERATION
- 1 a spark must light on all burners when the knobs on the top are pressed
- 2 when each knob on the cooktop is pressed and turned to the low flame symbol ( ), the entire crown should light.
- 3 lf burners do not light properly, turn the control knob to the "OFF" position O . Check that burner caps and crowns are in the proper position. Check that the power supply cord is plugged in and that circuit breaker or house fuse has not blown. Che...
- 6. WIRING DIAGRAMS
Instructions for the Installer
12
3)
Carefully position the gasket provided all around the outer edge of the hole inthe work surface as shown
in picture 1, pressing it down lightly to ensure it adheres properly. The front and rear sides of the gasket
must skim the hole. Now place the hob on the insulating gasket and use the screws and fixing brackets
(fig. 3) to secure the hob to the supporting structure, adjusting it until perfectly horizontal. Carefully trim
off the excess edge of the gasket A (pic.2). The dimensions in picture 2 below refer to the distance
between the hole and the inside edge of the gasket. Do not fit the brackets shown in pic. 3 until the hob
has been set in place.
1) 2)
3)
NOTE: Use all of the brackets supplied with the appliance to fasten it to the support structure.
4)
Use pipe-joint compound made for use with NATURAL and L.P.
gas. lf flexible metal connector is used, be certain tubing is not
kinked.