Instruction manual

Installation

Fixing to the flush built-in model support

structure

Create an opening with the dimensions

shown in the figure in the countertop of the

piece of furniture.

*If there is a piece of furniture above the hob. In case

of hood, refer to the values on the dedicated manual.

This kind of built-in application needs a

milling on the hob top of 3 mm in depth

(detail "B" in the picture above).

Before positioning the appliance, place the

supplied seal (C) on the milling.

L (mm) X (mm) Y (mm)

720 700 492

X (mm) Y (mm) G (mm) H (mm)

700 492 721 513

A (mm) B (mm) C (mm)* D (mm) E (mm)

min 110 min 460 min 750 20 - 40 min 50