Instruction manual

Installation
48
To prevent leakage of liquid between the
frame of the hob and the work surface,
carefully put the insulating seal provided in
position before assembly.
1. Refer to the dimensions in the figure,
bearing in mind that the front and rear
long sides must brush against the hole.
2. Make the seal stick to the edge around
the hole cut in the worktop, using a slight
pressure; front and rear sides of the seal
must brush against the hole.
3. Place the hob on the insulating seal and
fix it to the supporting structure using the
supplied screws and fastening brackets
(A) so that the hob is perfectly level.
4. Carefully trim the surplus away from the
edge (B) beyond the seal.
The brackets should be placed
only after the hob has been laid on
the seal.