Programs table

Table Of Contents

For Great Britain only

Warning: this appliance must be earthed.

Fuse replacement

If the mains lead of this appliance is fit-

ted with a BS 1363A 13amp fused plug,

to change a fuse in this type of plug use

an A.S.T.A. approved fuse to BS 1362

type and proceed as follows:

1. Remove the fuse cover (A) and

fuse (B)

2. Fit replacement 13A fuse into

fuse cover

3. Refit both into plug

Important:

The fuse cover must be refitted when changing a fuse and if the fuse cover is

lost the plug must not be used until a correct replacement is fitted.

Correct replacement are identified by the colour insert or the colour embossed

in words on the base of the plug.

Replacement fuse covers are available from your local electrical store.

If the appliance is provided with a plugless supply cord:

 It is necessary to install in the fixed wiring an all-pole disconnection

device having a gap between contacts of at least 3,5mm. After instal-

lation the disconnection device has to be easy to reach.

 The connection to the mains must be carried out by a qualified tech-

nician in accordance to the scheme shown below and the regulations

in force

= brown

= blue

= yellow-green

 In the event of damage to the supply cord, it has to be replaced by

the manufacturer or an authorized technical service center in order

to avoid any risk.

The manufacturer declines all responsibility

for injury or damage caused

by failure to comply with the above regulations or deriving from tampering with

even just one part of the appliance and the use of non-original spare parts.