Programs table

Table Of Contents

6.5 CLEANING THE DETERGENT DRAWER

The detergent drawer should be kept clean, removing all solid

deposits.

To simplify this operation, completely remove the detergent

drawer (pull the drawer fully out, press in the zone marked PUSH

and then remove completely).

Remove the siphon "A" and clean all parts with hot water.

Fully re-insert the siphon and remove any detergent deposits be-

fore putting the drawer back in position.

6.6 CLEANING THE WATER INTAKE FILTERS

The machine is fitted with a filter which protects the water intake valves.

The filter is in the fitting on the intake hose which is connected to the tap

The filter must be cleaned if the washer-dryer is not taking in water or the

amount of water is insufficient.

To clean, proceed as follows:

 Remove the mains plug to disconnect the appliance from the

electricity supply.

 Turn off the water tap.

 Unscrew the intake hose fitting from the tap.

 Remove the intake hose fitting filter.

 Clean the filter with water, with the aid of a small brush.

 When screwing the intake hose fitting back into place, check that the filter is positioned

correctly.

6.7 PERIODIC CLEANING

Carry out periodic cleaning to keep the appliance in good working order (see CLEANING AND

MAINTENANCE section) to prevent the build-up of limescale, unpleasant odours and

mould. A descaler can be used, following the instructions supplied with the descaler. Clean

the dispenser drawer at least once or twice a month to avoid the build-up of detergent.

Periodically check the water supply filters. See the procedure outlined in the manual.