User manual

24 / EN
Door, door-hinges and front of the
appliance
1. These parts must always be clean, especially
the contact surfaces between the door and
the front of the appliance, so that there are no
leaks.
2. To clean, use a neutral detergent and lukewarm
water. Dry with a soft cloth.
Mica covers
Always keep the mica covers clean. Food
remaining in the covers may deform it or produce
sparks if they go on fire. Therefore, they should be
cleaned on a regular basis, but abrasive cleaning
products or sharp objects should not be used. Do
not remove the covers, to avoid any risk.
4.6. Troubleshooting
The appliance does not function properly:
• Is the power plug correctly inserted in the
socket?
• Is the door properly closed? The door should
make an audible click when it closes.
• Are there any foreign bodies between the door
and the ring?
The foods do not heat up or they heat very
slowly:
• Did you use a metallic dish by mistake?
• Did you select the right operating time and
power level?
• Did you place a larger or colder amount of
food than usual in the microwave?
The food is too hot, dry or burned:
• Did you select the right operating time and
power level?
The display shows “HOT”!
• The temperature in the components
compartment reached a safety limit. Check
the installation conditions.
There are noises while the appliance is in
operation:
• Is there an electrical arch inside the
microwave?
• Is the dish coming into contact with the walls
of the cavity?
• Are there loose skewers or spoons inside the
microwave?
The inside lighting does not come on:
• If all of the functions are operating correctly,
the bulb is probably blown. You may continue
to use the appliance.
• The light bulb may only be replaced by the
Technical Support Service.
The power cable is damaged
• The power cable must be replaced by the
manufacturer, authorised agents or
technicians that are qualified to perform this
task, in order to avoid dangerous situations
and because special tools are needed.
If the problem has not been resolved or
in the case of other types of fault,
contact your local technical support
centre.
All repairs must be performed by
specialised technicians.
Cleaning and Maintenance