User manual

Instructions for the Installer
4
3. INSTALLATION AND CONNECTION
3.1 Choice of location and ventilation
WARNING
Excessive Weight Hazard.
Use two or more people to move and install this minibar.
Failure to do so can result in back or other injury.
Always place the minibar
in a dry place with satisfactory ventilation. Never expose it to direct sunlight or
install it outdoors.
The compressor type cool
ing system produces heat and requires good ventilation so rooms with poor
ventilation are not very suitable.
WARNING: Keep ventilation openings, in the minibar enclosure or in the built-
in structure, clear of
obstruction.
The minibar should be installed in a room in which there is a ventilation opening and it is essential not
to obstruct the grilles that allow the minibar to be well ventilated. Avoid positioning the minibar where it
is exposed to directly sunlight or close to other sources of heat. If this is unavoidable, in order to
prevent the proper operation of the product from being compromised, a suitable insulation board must
be used. Otherwise, locate the minibar at least 1¼” (3 cm) away from electrical or gas cookers and at
least 12⅛” (31 cm) away from combustion heaters or radiators.
Minimum installation distances:
from the top: 2’’ (50 mm). If it is not possible to guarantee this distance, a ventilation
opening with the dimensions and position shown in the figure below is required.
from the back: 2” (50mm)
from the sides: 2” (50mm)
from the floor:
maximum feet length
To allow proper cooling of the condenser, the minibar must not
be placed too close to the wall. To prevent this, there are two
plastic spacers at the lower back of the minibar.
Position the minibar so that the door can be opened fully.
Take
care not to scratch or damage the floor when installing the
minibar on parquet or linoleum. If necessary, when positioning
slide the minibar over pieces of wood or a mat to the point
decided for connection to the electrical mains.