Instruction manual

User instructions
16
END OF PROGRAM
At the end of the program the beeper sounds briefly and
the program
lights
4
and
5
(marked "end") flash.
INTERRUPTION A PROGRAM
To interrupt a program in progress:
 press the START/PAUSE button (6); the light of the program in
progress remains on (confirmation beep);
 you may now restart the program by pressing button (6) again until it
restarts, or change or annul the program (see "CHANGING A PROGRAM",
or "
A
NNULLING A PROGRAM").
CHANGING A PROGRAM
To change the running program it is necessary:
 to interrupt the running program (see “INTERRUPTION A PROGRAM”);
 select the new program;
 start the program (see “
S
TARTING THE PROGRAM”).
ANNULLING A PROGRAM
To annul the program, keep the START/PAUSE button (6) pressed until
the program is interrupted (light on and confirmation beep).
Press button (6) again and keep it pressed until the
program
lights
4
and
5
(marked "end") come on.
The water in the tank will be pumped out and the program will end at the
point where it was interrupted.