Instruction manual

Cleaning and maintenance
83
EN
Cleaning of racks and trays
Clean the racks and trays with warm water
and non-abrasive detergents. Carefully
rinse and dry damp parts.
Removing racks/trays support frames
Removing the guide frames enables the
sides to be cleaned more easily. This
operation should be performed each time
the automatic cleaning cycle is used (on
some models only).
To remove the guide frames. Pull the frame
towards the inside of the oven to unhook it
from its groove A, then slide it out of the
seats B at the back.
When cleaning is complete, repeat the
above procedures to put the guide frames
back in.
Cleaning the evaporation tray and cover
It is recommended that you clean and dry
the evaporation tray and the perforated
cover after using the Direct Steam function.
Common cleaning products can be used:
avoid using products that are too harsh
and/or acidic.
The cover and the tray can be washed in a
dishwasher.
If limescale forms, use a limescale remover
for steel surfaces.
Cleaning the lower part
It is recommended that you clean and dry
the bottom of the oven after using the Direct
Steam function:
1. Remove in sequence, the perforated
cover (1), the evaporation tray (2) and
the bottom (3); lift the bottom by a few
millimetres and pull it outwards.