Contents 1.1 1.2 1.3 1.4 1.5 1.6 General safety instructions Appliance purpose Disposal Identification plate This user manual How to read the user manual 2 Description 2.1 General Description 2.2 Description of parts 2.3 Control panel 3 Use 3.1 3.2 3.3 3.4 3.5 3.6 3.7 3.
Instructions 1 Instructions 1.1 General safety instructions Risk of personal injury • Keep children under the age of 8 at a safe distance unless they are constantly supervised. • According to the current regulations, children between 3 and 8 years of age can take or load food from the appliance, but it is strongly advised against allowing children under 8 years of age to perform these operations and in general to use the appliance. • Children must never play with the appliance.
• • • • • • • • • • • • • metallic sponges) on glass parts. Do not use rough or abrasive materials or sharp metal scrapers. Do not sit on the appliance. Do not rest any weight or sit on the open door of the appliance. Take care that no objects are stuck in the doors. Do not store inflammable, explosive or volatile substances. Organic compounds, acids and essential oils can corrode the seals and plastic surfaces if left in contact with them for extended periods.
Instructions • • • • • • • • out installation and assistance interventions according to the standards in force. Have the electrical connection performed by authorised technicians. The appliance must be connected to ground in compliance with electrical system safety standards. Use cables withstanding a temperature of at least 90 °C. The tightening torque of the screws of the terminal board leads must be 1.5 - 2 Nm.
Instructions This appliance must be disposed of separately from other waste (Directives 2002/95/EC, 2002/96/EC, 2003/108/EC). The appliance does not contain substances in quantities sufficient to be considered hazardous to health and the environment, in accordance with current European directives. To dispose of the appliance: • Cut the power supply cable and remove it along with the plug. Power voltage Danger of electrocution • Disconnect the mains power supply. • Unplug the appliance.
Instructions 1.6 How to read the user manual This user manual uses the following reading conventions: Instructions General information on this user manual, on safety and final disposal. Description Description of the appliance and its accessories. Use Information on the use of the appliance and its accessories. Cleaning and maintenance Information for proper cleaning and maintenance of the appliance. Installation Information for the qualified technician: Installation, operation and inspection.
Description 2 Description EN 2.
Description 2.2 Description of parts Smeg Connect Fan (not visible) The appliance is equipped with the Smeg Connect technology so that the user can control its operation through an App on his smartphone or PC tablet. For further information, refer to the supplied brochure and/or visit the site www.smeg.com Distribute the temperature and reduce condensation on the shelves and other surfaces.
Description EN 2.3 Control panel The control panel allows the user to interact with the appliance. Touch the keys with symbols to access the available functions. Light key This key turns the lighting inside the wine cellar on and off. The lighting turns off after a maximum period of 15 minutes. Alarm key This key turns off the audible warning when an alarm is activated. Connection key By this key you can activate the connectivity functions.
Use 3 Use 3.3 First use 3.1 Instructions To turn on the appliance: 1. insert the plug into the power socket; Improper use Risk of damage to the appliance • Do not rest any weight or sit on the appliance door. • Do not store inflammable, explosive or volatile substances. • Organic compounds, acids and essential oils can corrode the seals and plastic surfaces if left in contact with them for extended periods. • Do not obstruct the openings of the ventilation grille in any way.
3.4 Opening and closing the door Push-pull mechanism 1. To open the door, just apply light pressure to the bottom left area. A pushpull mechanism will delicately push the door, detaching it from the magnet. It may be necessary to adjust the push-pull mechanism to optimise door opening and closing. 1. Open the door. 2. Rotate the piston of the push-pull mechanism to the right or left to obtain the required adjustment. It will then be possible to fully open the door. 2.
Use 3.5 Using the control panel Manual ventilation Interior lighting The interior lighting is provided by an LED light bar installed at the top of the wine cellar. To activate and deactivate the interior lighting: 1. press the ON/OFF the control panel. key to activate 2. press the Light key. The symbol on the Light key will flash. To deactivate the interior lighting: 3. Press the Light key again. Manually operated interior lighting will stay on for a maximum of 15 minutes.
Use 1. press the ON/OFF the control panel. key to activate 2. Press the fan key. The symbol on the fan key will flash. To deactivate manual ventilation: 3. Press the fan key again. If the door is opened, the fans will be deactivated. The fans then reactivate when the door is closed. Connectivity Connectivity requirements: • Smartphone or PC tablet with IOS version 10.x or higher or Android version 5.1 or higher. • Wi-Fi connection (2.
Use 3.6 Using the wine cellar Demo mode (for showrooms only) Turns off the appliance's fans and compressor while keeping the control panel active. Bottle arrangement To activate demo mode: 1. press the ON/OFF the control panel. 2. Press and hold the fan lock key to activate and control keys simultaneously for around five seconds. The text appear on the display. will (max 18 bottles) Each shelf can hold up to 6 standard 0.75 litre wine bottles. 3. Press the fan key.
Use Activated charcoal filter To maintain optimum air quality inside the wine cellar, the activated charcoal filter must be replaced at least once a year. To replace the activated charcoal filter: 1. Turn the filter cap 90° to the left or right. Improper use Damage and injury hazard 2. Extract the cap from its seat. • Do not place bottles sideways on the base of the wine cellar. They could fall when the door is opened. 3. Replace the activated charcoal filter with a new one. 4.
Use Noises during operation The wine cellar is cooled by means of a compression system. In order to maintain the preset temperature inside the wine cellar, the compressor comes into operation in response to the level of cooling required, and may operate continuously if necessary. When the compressor starts to function, it creates a buzzing noise which generally diminishes in intensity after a few minutes.
Use Connectivity alarms Alarm key and wait for the temperature to return within the normal storage values. It may be necessary to repeat this operation 1–2 times. The APP shows Alarm for door open The display shows : the door has been left open for more than 60 seconds • Close the door. The alarm will reactivate in the same way 60 seconds after it is shut off if the door is still open. Fault alarms ( excluded) or or to or : appliance fault. • Switch off the appliance and call Technical Support.
Use Rosé wines Sparkling wines Generally, the rules for serving rosé wines are the same as for whites. However, it is important to consider these wines' tannin content and serve them at a higher temperature if necessary so that their flavour is not too sharp. Tannin content permitting, young, fresh rosé wines are served between 10°C and 12°C, while more robust, full-bodied types, including more mature wines, can be served between 12°C and 14°C.
Dessert wines and fortified wines Storage temperatures These two types of wine generally both contain a high alcohol percentage and they are both often also sweet. However, there are dry dessert wines, such as Marsala, with a sugar content so low as to be almost imperceptible on the palate. For these wines, the serving temperature depends on which features you wish to emphasise.
Cleaning and maintenance 4 Cleaning and maintenance 4.1 Instructions Improper use Risk of damage to surfaces • Do not use steam jets to clean the appliance. • Do not use cleaning products containing chlorine, ammonia or bleach on parts made of steel or that have metallic surface finishes (e.g. anodizing, nickelor chromium-plating). • Do not use abrasive or corrosive detergents (e.g. scouring powders, stain removers and metallic sponges) on glass parts.
Cleaning and maintenance To refit the removable shelves The removable shelves can be extracted from the interior of the wine cellar to facilitate cleaning. 5. Line up the shelf with the four pins of the guide and rest it on this. EN Removing the removable shelves To extract the removable shelves 1. Open the door. 2. Extract one of the two shelves. 6. Push the shelf inside the wine cellar. 3. Lift the shelf removed upwards. 7. Repeat the operation for the other shelf. 8. Close the door. 4.
Cleaning and maintenance 4.3 What to do if... The appliance does not work: • Make sure that the appliance is plugged in and that the main switch is turned on. The compressor starts to function too often or functions continuously: • The room temperature is too high. • The door is being opened too often or for too long. • The door is not closing/sealing properly. • There is an excessive quantity of warm bottles.
Installation 5.1 Electrical connection Power voltage Danger of electrocution • The appliance must be connected to ground in compliance with electrical system safety standards. • Do not pull the cable to remove the plug. General information • Check the mains characteristics against the data indicated on the plate. The identification plate bearing the technical data, serial number and brand name is visibly positioned inside the appliance. Do not remove this plate for any reason.
Installation Class Room temperature SN + 10°C to + 32°C N + 16°C to + 32°C ST + 16°C to + 38°C T + 16°C to + 43°C SN-ST + 10°C to + 38°C SN-T + 10°C to + 43°C Appliance overall dimensions (mm) SN = Subnormal - N = Normal ST = Subtropical - T = Tropical 1. Install the appliance at least 3 cm away from electrical or gas cookers and at least 30 cm away from combustion heaters or radiators. 2. The appliance must not be installed near heat sources.
Installation EN Mounting (mm) Do not cover the ventilation holes.
Installation Fastening trim bar The appliance is fitted with a (removable) fastening trim bar to fasten it below the kitchen worktop. To fasten the appliance to a kitchen worktop: 1. Open the door. 2. Use the 4 screws supplied to fasten the appliance.
