User manual

12 - USE 914779624/B
Remote connection
To disconnect the device:
1. At any time, press the
Connection key.
2.
The Connection key stops flashing and
becomes solid again.
To connect the device again:
1. At any time, press the
Connection key.
2. The Connection key starts flashing. For
a few seconds the display will show
alternately with the value of the temperature,
until the Internet connection is completed.
Change Access Point credentials
To change your Access Point credentials
(network name or password):
1. Log in the App, tapping Log in.
2. In the Settings menu of the product pages
select Change Access Point.
3. Press any key on the device to activate the
control panel.
4. Hold down the Connection key for a
few seconds. The device enters the
SmegConnect menu; the display shows
.
5. Press and hold the ON/OFF
key within
30 seconds until it starts flashing.
6. Select Manual mode.
7. Go to the Wi-Fi settings on the mobile
device and select the “smegconnect”
network.
8. Enter the password “smeg0001” and wait
for the connection to be established.
9. Go back to the SmegConnect App and tap
Next.
10.Press the
Fan key on the appliance
within one minute, to confirm your presence.
The Connection key starts flashing.
11.Enter the Access Point data:
• Name of the home Wi-Fi network.
• Wi-Fi password.
12.Tap Next and wait for the confirmation
page.
13.Wait for the confirmation acoustic signal.
The Access Point credentials change procedure
is completed.
The device is connected to the Internet and can
Once the device is registered, it can be
connected or disconnected from the
Internet at any time.
The remote connection is only available
if the device has been registered.
The procedure can be interrupted at
any time by pressing the
Connection
key.
On some models only, the ON/OFF
key is lit only if the product has already
been registered.
The device supports network names
(SSID) up to 24 digits (including
spaces) and WPA2 security settings
(not WEP or WPA).
During this step, the mobile device
automatically reconnects to the initial
Wi-Fi network or data network. No user
operation is required.