User manual

Installation
20
Gas connection
Connect the adapter C (ISO 228/1 -
½ NPT) to the gas inlet of the appliance A
being sure to insert the supplied gasket B.
Apply a suitable sealing substance (such as
Teflon tape) between pressure regulator D
and adapter C.
Connect the pressure regulator D to the
adapter C put on in the previous step (the
arrow on the back of the regulator points
towards the gas inlet of the appliance).
Apply a suitable sealing substance (such as
Teflon tape) between pressure regulator D
and adapter E (½ NPT - ½ NPT) (not
supplied).
Connect the adapter E to the pressure
regulator D.
Due to problems of overall dimensions at
the back, screw in the pressure regulator so
that it is sloped at 45° vs the wall at the
back of the appliance.
WARNING: The tightening torque
of adapter (C / E) must not be
greater than 36 ozf - 10 Nm.