User manual
Installation
23
EN
4. Line up the hole on the side skirting with 
the rear hole on the base of the 
appliance.
5. Fasten the side skirting to the appliance 
using the previously removed screw.
6. Repeat the operations described above 
for the other side skirting section.
1.7 For the installer
•  The plug must remain accessible after the 
installation is complete. Do not kink or 
trap the mains connection cable.
• The appliance must be fitted according 
to the installation diagrams.
• Do not attempt to turn or stress the 
threaded elbow on the manifold. You risk 
damage to this part of the appliance 
which may void the manufacturer’s 
warranty.
• Before leaving check all connections for 
gas leaks with soap and water. DO 
NOT use a naked flame for detecting 
leaks.
• Ignite all burners individually and 
concurrently to ensure correct operation 
of the gas valves, burner and ignition.
• Turn the gas knobs to the low position 
and observe stability of the flame for 
each burner individually and all together.
• In case the appliance fails to operate 
correctly after all checks have been 
carried out, refer to the Authorised 
Assistance Centre in your area.
• When satisfied with the appliance, 
please instruct the user on the correct 
method of operation.










