Technical data

51
•
Instructions for the installer
11. INSTALLATION
•
• •
11.1 Installing in kitchen units
• •
Veneers, adhesives or plastic coatings on adjacent furniture should be temperature-resistant (no less
than 90°C). If they are not sufficiently temperature-resistant, they may warp over time.
• •
•
The appliance must be installed by a qualified technician and according to the regulations in force.
Depending on the type of installation, this appliance belongs to class 2, subclass 1 (Fig. A - Fig. B) or to
class 1 (Fig. C).
It may be installed next to walls, one of which must be higher than the worktop, at a minimum distance of
150 mm from the side of the appliance, as shown in figures A and C relative to the installation classes.
Make sure that there is a minimum distance of 750 mm between the stoves and any shelf that may be
installed directly above it. If a hood is installed above the hob, refer to the hood instruction manual to
ensure the correct clearance is left.
Built-in appliance
(Class 2 subclass 1)
Built-in appliance
(Class 2 subclass 1)
Free-standing appliance
(Class 1)
11.2 Positioning the skirt
• • •
The skirt must always be positioned and secured correctly on
the appliance.
1 Loosen the 4 screws (A) on the back of the worktop (2 for
each side).
2 Place the skirt above the worktop, taking care to align the
skirt's slots (B) with the screws (A).
3 Secure the skirt to the worktop by tightening screws (A).