Technical data

Instructions for the user

9.5.1 Removing guide frames

Removing the guide frames enables the sides to be cleaned more easily.

To remove the guide frames:

1 Pull the frame towards the inside of the

oven to unhook it from its housing A, then

slide it out of the seats B at the back.

2 When cleaning is complete, repeat the

above procedures to put the guide frames

back in.

9.6 Cleaning the door glazing

The glass in the door should always be kept thoroughly clean. Use absorbent

kitchen roll; remove stubborn dirt with a damp sponge and an ordinary

detergent.

Do not use abrasive or corrosive detergents to clean the oven's door glass

panels (e.g. powder products, spot-removers and wire sponges).

Do not use rough or abrasive materials or sharp metal scrapers to clean the

oven's glass doors since they may scratch the surface.

9.7 Removing the door seal (not on pyrolitic models)

To permit thorough cleaning of the oven, the

door seal may be removed.

There are fasteners on all four sides to attach it

to the edge of the oven. Pull the edges of the

seal outwards to detach the fasteners. The seal

must be replaced when it loses elasticity and

hardens.