Instruction manual

Installation
99
EN
2. Secure the upstand to the top by
tightening screws C.
Installing the grilled strip
If the appliance is installed as an island, the
strip provided should be installed instead of
the upstand.
Use the 3 screws, provided, to secure the
strip to the hob. Fasten it using the middle
screw (1) first and then the side screws (2).
Keep a minimum clearance of 150 mm
between the appliance and the other
furnishings or decorative elements
according to the diagram below.
Any wall units positioned above the
worktop must be at a minimum distance of
at least 750 mm. If a hood is installed
above the appliance, refer to the hood
instructions manual to make sure the correct
clearance is left.
The strip should only be installed if
the appliance is installed as an
island.
Improper use
Risk of damage to the appliance
• Be careful not to allow any solids or
liquids to enter the slots in the grille strip.