User's Manual

5 Wireless shooting
Press the shutter button on the transmitter halfway down to focus and press it all
the way down to release.
Warning : -Replace a fresh battery when the LED’s on the receiver are dimmed.
Weak battery may cause the receiver not to perform the Bulb shooting properly.
Connect the Receiver to your camera
Slide the transmitter into the hot shoe of your camera.
The receiver has a clip type hot shoe. It can be attached to camera strap when the
hot shoe of camera is occupied by a flash unit
To Use RFN-4 Receiver Wired
Normal Shooting
RFN4 receiver can be used as a wired shutter release separately. Connect the
receiver to the camera’s electronic shutter release input using the appropriate
accessory cable. Press the triggering button on the receiver halfway to focus on the
subject and press it fully to operate shutter function.
NOTE – The battery is not required when the receiver is used as a separate remote
release.
Bulb Shooting
The RFN4 supports the Bulb shooting on cameras which have a bulb mode. Please
set your camera on the bulb mode. Slide forward the triggering button. You will see
orange band on it.
To end the bulb shooting, slide back in its original position
Warning! The triggering button on the receiver should be unlocked after bulb
shooting
RFN4 TX –Set Up
1 Battery Installation
Install AAA battery into the battery holder. Observe the polarity of battery as
indicated
2 Normal Shooting
Press the triggering button halfway on the transmitter unit to operate auto focus
function. Press the triggering button fully to take a picture.