User's Manual

For portable flash unit
Mount the flash directly on the receiver’s hot shoe. Connect the flash unit to a tripod or a light
stand through the 1/4” female threads on the back of the receiver.
For studio flash
Connect the supplied 3.5mm mono male plug cord to your flash unit’s sync input. If your flash
equipment provide 6.3mm sync socket to connect the receiver, connect the supplied 6.3mm
sync adapter to the 3.5mm mono plug cord.
Switch on the power of the receiver
Channel Setup
Flash Wave III provides sixteen channels.
Both the transmitter and receiver must be set to use the same channel. Use the supplied small
driver to set the channel. There is a mini plastic pin on the battery cover of the transmitter to
change the channel. Both the transmitter and the receiver must be turned off and on after
selecting the channels.
Triggering A Remote Camera
Flash Wave III can be used to trigger a remote camera with the addition of an accessory
release cable.
Connect the Flash Wave III receiver to the electronic shutter release connection on your camera
using the compatible camera release cable.
Set the same channel both on the transmitter and the receiver and power on.
Press the TEST button on your Flash Wave III Transmitter to trigger your remote camera.
Flash Wave III Trigger & Receiver Kit Contents:
1 - Radio Trigger(Battery Installed: CR2450 3V)
1 - Radio Receiver(Battery Required: two “AA” 1.5V)
1 - Synch Cord Adapter 3.5mm-6.3mm
1 - Synch Cord (for camera)
1 - Synch Cord (for strobe light)
1 – Plastic Hotshoe and grip for Receiver
1 - Instructional Manual
Warranty
S.M Development guarantees all our products for one year from date of purchase. We will repair
or replace any our products that become defective during the period. Defective units should be
sent back to us with a message describing the defects.