User's Manual

Flash Wave III
Product Details:
The Flash Wave III is a digitalized radio trigger system designed for photographic studios and
on-location work. It is composed of two units: a radio Transmitter and a digital Receiver, both
easily installed on any type of light. The upgraded Flash Wave III systems can trigger your
remote camera with a compatible camera release cable. It provides a two step test triggering
button in order to perform auto focus function & shooting function.
The Flash Wave III will eliminate flash slave interference among strobe lights in your studio.
Features
1. Sixteen (16) selectable channels
2. A triggering speed of up to 1/250 second for focal plane shutter
3. Operational range : up to 80 meters line of sight
4. Built-in Hotshoe on the Receiver
5. A trigger battery with a lifetime of up to one year, or over 20,000 triggers
6. Low Voltage Trigger, No Damage to Camera
7. Test button on Trigger
8. LED signals for each trigger/reception
9. Receiver adapters for the synch cord outlets of different strobes
10. Various sync sockets on the Receiver- PC Terminal, 3.5mm mini phone plug, Built-in
Hotshoe
User Guide
Set Up Transmitter
Install a CR2450 3V Lithium coin cell into the transmitter
There are two methods to connect the transmitter to your camera.
One method is to slide the transmitter to the hotshoe of your camera.
The other method is to connect the supplied sub-mini(2.5mm) phone jack to the transmitter,
located on the side of the unit, then plug the other end of the cord into the PC connection on
the camera.
Switch on the power of the transmitter.
Transmitter has a test button to verify your set up.
Set Up Receiver
Your flash equipment should be OFF.
Install two AAA 1.5V batteries into the receiver. Observe the polarity of the batteries as
indicated.