User's Manual

MySlave-100-Kit
Product Details:
The MySlave-100-Kit is a digitalized radio trigger system designed for photographic studios and
on-location work. It is composed of two units: a radio Transmitter and a digital Receiver, both easily
installed on any type of light. The MySlave-100-Kit can be used with a variety of studio flashes,
strobes (AC & DC), and monolights (monobloc). The MySlave-100-Kit will eliminate flash slave
interference among strobe lights in your studio.
Features
1. Ten (10) optional channels
2. A triggering speed of up to 1/180 second
3. Operational range : 50~60 meters
4. Built-in Hotshoe on the Receiver
5. A trigger battery with a lifetime of up to one year, or over 20,000 triggers
6. Low Voltage Trigger, No Damage to Camera
7. Test button on Trigger
8. LED signals for each trigger/reception
9. Receiver adapters for the synch cord outlets of different strobes
10. Various sync sockets on the Receiver- PC Terminal, 2.5mm sub-mini phone plug, Built-in
Hotshoe
User Guide
1. Insert 23A 12V battery into the Transmitter.
2. Affix the TRANSMITTER to the hot shoe of your camera or use the supplied pc cord by
inserting the mini phone (male end) plug in the hole on the side of the TRANSMITTER
and then the PC end of the cable into your camera’s PC terminal.
3. Insert the 3 pcs of “AAA” batteries into the RECEIVER. (Observe the polarity of the
batteries as indicated)
4. Connect the RECEIVER to your strobe properly in one of two ways;
a) Receiver provides a PC to 3.5mm phone jack plug cable for connecting the output to
your flash unit’s sync input.
OR
b) Mount your portable flash unit into the built-in Hotshoe on the RECEIVER directly.
5. Using a mini flat ended screw driver, dial in the same channel number (1-10) on the
channel selector both the TRANSMITTER and RECEIVER.
6. There is a test button on the top of the TRANSMITTER that can be used to verify that
the system is operational. The Status button flashes blue to indicate synchronization.