User's Manual

Flash Wave 2
Product Details:
The Flash Wave 2 is a digitalized radio trigger system designed for photographic studios and on-
location work. It is composed of two units: a radio Transmitter and a digital Receiver, both easily
installed on any type of light. The Flash Wave 2 can be used with a variety of studio flashes,
strobes (AC & DC), and monolights. The Flash Wave 2 will eliminate flash slave interference
among strobe lights in your studio.
Features
1. Ten (10) optional channels
2. A triggering speed of up to 1/200 second
3. Operational range : up to 60 meters
4. Built-in Hotshoe on the Receiver
5. A trigger battery with a lifetime of up to one year, or over 20,000 triggers
6. Low Voltage Trigger, No Damage to Camera
7. Test button on Trigger
8. LED signals for each trigger/reception
9. Receiver adapters for the synch cord outlets of different strobes
10. Various sync sockets on the Receiver- PC Terminal, 3.5mm mini phone plug, Built-in Hotshoe
User Guide
1. Insert 23A 12V battery into the Transmitter.
2. Attach the Transmitter into the hotshoe of the camera. If your camera lacks a hotshoe,
connect the supplied 2.5mm sub-mini phone jack into the Transmitter.
3. Insert the 2 pcs of “AAA” batteries into the RECEIVER. (Observe the polarity of the
batteries as indicated)
4. Connect the RECEIVER to your strobe properly in one of two ways;
a) Receiver provides a 3.5mm mini jack input and PC sync socket for connecting to the
most flash units via accessory cable.
OR
b) Mount your portable flash unit onto the built-in Hotshoe on the RECEIVER directly.
5. Turn the Channel Selection Dial to a desired Channel, on both the Transmitter and
Receiver. The Channels must be on the same Channel setting.
6. The Transmitter is confirmed On, by pressing the Test button, denoted by an Electric
arrow. The Status button flashes blue to indicate synchronization.