Datasheet

ManualsBrandsSMC ManualsAutomation3/2-Way Solenoid 24 VDC 133 Pa...1.0 MPa 3/2 Opener (N.C.)

Standard Specifications

Characteristic Specifications

VDW200

VDW300

Model

ø1

ø1.6

ø2

ø3

ø4

0.9

0.7

0.8

0.4

0.2

0.54 (0.03)

1.2 (0.07)

2.8 (0.16)

5.0 (0.28)

8.0 (0.44)

0.3

0.1

0.2

0.1

0.05

Orifice

size

Weight

Port size

1/8 (6A)

1/4 (8A)

0.12

0 to 1.0

1/8: 0.27

1/4: 0.30

Note 2)

Note 1) Effective area is for the case when IN is normally closed (N.C.).

Note 2) Indicates the maximum operating pressure differential of pressure ports 2 and 3.

Note 3) The maximum operating pressure differential changes depending on the flow direction of the fluid.

Refer to page 21 for details.

Note 4) For low vacuum specifications, the operating pressure range is 1Torr (1.33 x 10

²Pa) to 1.0MPa.

Consult SMC if used below 1Torr (1.33 x 10

²Pa).

Valve specifications

Coil

specifications

Valve construction

Fluid

Note 2)

Withstand pressure MPa

Ambient temperature °C

Fluid temperature °C

Environment

Valve leakage cm

/min

Mounting orientation

Vibration/Impact m/s

Note 4)

Rated voltage

Allowable voltage fluctuation %

Coil insulation type

Enclosure

Note 5)

Power consumption W

Note 3)

Maximum operating

pressure

differential MPa

Note 3)

Effective area

mm²

(Cv factor)

Note 1)

Operating

pressure

range

MPa

Note 4)

Pressure port 1

Pressure ports 2, 3

Direct operated poppet

Water (except waste water or agricultural water), Air, Low vacuum

2.0

–10 to 50

1 to 50 (with no freezing)

Location without corrosive or explosive gases

0 (with water pressure)

Unrestricted

30/150

24VDC, 12VDC, 100VAC, 110VAC, 200VAC, 220VAC (50/60Hz)

±10% of rated voltage

Class B

Dust proof (equivalent to IP40)

Note 1) Consult SMC when used under conditions which may cause condensation on the exterior of the product.

Note 2) When used with pure water, select "L" (stainless steel, FKM) for the material type.

Note 3) Since AC coil specifications include a rectifying device, there is no difference in power consumption for starting

and holding.

3.5W in case of 110/220VAC.

Note 4) Vibration resistance …No malfunction when tested with one sweep of 5 to 200Hz in the axial direction and at a

right angle to the armature, in both energized and deenergized states.

Impact resistance ….. No malfunction when tested with a drop tester in the axial direction and at a right angle to

the armature, one time each in energized and deenergized states.

Note 5) Consult SMC regarding drip-proof specifications (equivalent to IP54) .

Series

VDW200/300