Specifications

Management Guide CLI

TigerAccess™ EE

SMC7824M/VSW 91

The following table lists the sub-commands in the Bitloading per tone command.

Sub-command Description

tx-bit-ne Get Tx Per Tone BitLoading Info Near End

snr-ne Get Rx Per Tone SNR Info Near End

noise-margin-ne Get Rx Per Tone Noise Margin Near End

feq-ne Get Rx Per Tone Current FEQ ine Coeffs Near End

tx-pwr-ne Get Tx Per Tone Tx Power Near End

tx-gi-ne Get Tx Per Tone Gi Near End

qln-ne Get Rx Per Tone Quiet Line Noise Near End

coarse-feq-ne Rx Per Tone Coarse FEQ Near End

block Get Param Block Read Far End (valid for ADSL2/2+/VDSL2 only)

hlog-ne Get Per Tone HLOG Info Near End (valid for ADSL2/2+ only)

hlin-ne Get Per Tone HLIN Info Near End

hlin-scale-ne Get Per Tone HLIN Scale Near End

Tab. 5.8 Sub-commands in Bitloading Per Tone

5.3.2.13 G.handshake Tone

To configure G.handshake tone of each port, use the following command.

Command Mode Description

lre PORTS ghs a43 [i43] [v43]

lre PORTS ghs b43 [i43] [v43]

lre PORTS ghs none

Bridge

Configures G.hs tone carrier of each port

a43, b43, i43, v43: A43, B43, I43, V43 Carrier Set

none: None G.hs Carrier mode

You can not configure A43 G.hs carrier with B43 at the same time.

To display the G.hs Carrier configuration of each port, use the following command.

Command Mode Description

show lre ghs [PORTS]

Enable

Global

Bridge

Shows G.hs carrier configuration of each port.

5.3.3 VDSL Checking Errors of VDSL Port

In switch it is possible to check times of error from VDSL port every time interval. More-

over, it is possible to check the error duration time.

Checking Times of Errors

You can check how many times CRC errors, Frame loss and Signal loss are happened.

Error is counted every 15 minutes after booting. After the time is over, the number is reset

to “0” and error is counted again. In addition, error is counted by each day. It is also reset

to “0” after the day. Consequently, you can check times of error (Curr.15m) at present