Specifications

Management Guide CLI
TigerAccess™ EE
SMC7824M/VSW 85
To enable Interleave process, use the following command.
Command Mode Description
lre PORTS channel slow Bridge Enables Interleave process.
The default is Interleave enabled as “slow”.
The following is an example of displaying Interleave.
SWITCH(bridge)# show lre interleave 1-5
------------------------------------------
Port Status Channel Inter-Delay
ADM/OPR UP/DOWN
------------------------------------------
1 Up/Down Slow 2/ 2
2 Up/Down Slow 2/ 2
3 Up/Down Slow 2/ 2
4 Up/Down Slow 2/ 2
5 Up/Down Slow 2/ 2
SWITCH(bridge)#
In addition, you can configure the interval of Interleave process during modulation. This
interval is called Interleave-delay. By configuring Interleave-delay, you can prevent trans-
mission delay caused of waiting data gathered.
To configure Interleave-delay, use the following command.
Command Mode Description
lre PORTS interleave-delay
<1-100>
Configures Interleave-delay
PORTS: VDSL port number
1-100: interleave delay value (default:2 ms)
lre PORTS interleave-delay
<1-100> {upㅣdown}
Bridge
Configures Interleave-delay with specifying Upstream
or Downstream.
The unit of Interleave-delay is “㎳” and the default is “2ms”.
In switch, all VDSL ports are contained in one Line-config-profile. For the ports contained
as the member port of Line-config-profile, it is not possible to change Interleave-delay or
SNR margin.
To change it independently, erase the member of Line-config-profile first refer to
5.3.4.1
Line config profile. If you try to configure interleave-delay of the port which is contained as
Line-config-profile member, the error message will be displayed.
i
i
!