Specifications

CLI Management Guide

TigerAccess™ EE

80 SMC7824M/VSW

To control supplied power according to VDSL line, use the following command.

Command Mode Description

lre PORTS upbo enable Bridge

Controls supplied power according to distance of VDSL

line.

You should control supplied power of VDSL port according to distance of VDSL line.

To disable power control according to distance of VDSL line, use the following command.

Command Mode Description

lre PORTS upbo disable Bridge

Disables power control according to distance of VDSL

line.

The following is an example of disabling power control according to distance of VDSL line.

SWITCH(bridge)# lre 1-3 upbo disable

SWITCH(bridge)# show lre psd 1-5

-----------------------------------------------------------

Port Status Up Stream PBO Length PSD MASK

ADM/OPR PBO (10 Custom) Level

---------------------

| u 0 | u1 | u2 | u3 |

-----------------------------------------------------------

1 Up/Up disable | 2 | 2 | 2 | 2 | 11

2 Up/Up disable | 2 | 2 | 2 | 2 | 11

3 Up/Down disable | 2 | 2 | 2 | 2 | 11

4 Up/Down Enable | 2 | 2 | 2 | 2 | 11

5 Up/Down Enable | 2 | 2 | 2 | 2 | 11

SWITCH(bridge)#

If you control power according to VDSL line, it is applied to all ports.

You cannot configure power consumption supplied to VDSL line with power control ac-

cording to the distance of line enabled. In this case, the standard to decide power con-

sumption is the distance.

To configure power consumption supplied to VDSL line, use the following command.

Command Mode Description

lre PORTS pbo-length {1ㅣ2ㅣ3

ㅣ4ㅣ5ㅣ6ㅣ7ㅣ8ㅣ9ㅣ10}

Bridge

Configures power consumption supplied to VDSL line

according to the distance.

The default is “2”.