Specifications

Management Guide CLI
TigerAccess™ EE
SMC7824M/VSW 77
5.3.2.1 Displaying Status of VDSL Port
You can check status of VDSL port and user’s configuration. It is also possible to view in-
formation of VDSL port. To check status of VDSL port and information of DMT modulation,
use the following command
Command Mode Description
show lre [PORTS] Shows VDSL port.
show lre detail-info [PORTS] Shows detailed information of VDSL line.
show lre user-mac [PORT]
Shows MAC address of user connected
to VDSL ports.
show lre profile [PORTS] Shows the VDSL profile
show rate-info[PORTS] Shows the rate information of VDSL line.
show lre psd [PORTS]
Enable
Global
Bridge
Shows PSD-mask-level
The above commands shows the following information. Therefore, you can choose com-
mand according to information you need.
Command Description
bitload Shows Bitloading Per Tone
ewl Shows Electronic Wire Length
ham-band Shows HAM Band
inp Shows Upstream / Downstream Protection
interleave Shows interleave-delay
pbo-config Shows Power Back-Off Length configuration
profile Shows Profile
psd Shows PSD
rate-info Shows rate information
snr Shows SNR Margin
Tab. 5.1 Information displayed by Command, show lre
5.3.2.2 Enabling VDSL Port
This configuration of enabling VDSL port has different way of using with the configuration
described in “
Ethernet Port Configuration” Enabling VDSL port is to configure Sync status
of partner’s equipment. Therefore, although you connect to cable with VDSL port down,
Sync is not configured. To configure Sync status of VDSL port, use the following com-
mand.
Command Mode Description
lre PORTS up
Configures Sync with partner’s equipment or resets
VDSL port.
lre PORTS down
Bridge
Disables Sync with partner’s equipment.
Sync with the connected equipment is basically configured for VDSL port.
!