Specifications

CLI Management Guide
TigerAccess™ EE
48 SMC7824M/VSW
4.2.4 RADIUS Server
4.2.4.1 RADIUS Server for System Authentication
To add/delete a RADIUS server for system authentication, use the following command.
Command Mode Description
login radius server A.B.C.D
KEY [auth_port PORT acct_port
PORT]
Adds a RADIUS server with its information.
A.B.C.D: IP address
KEY: authentication key value
auth_port: authentication port (optional)
acct_port: accounting port (optional)
no login radius server [A.B.C.D]
Global
Deletes an added RADIUS server.
You can add up to 5 RADIUS servers.
4.2.4.2 RADIUS Server Priority
To specify the priority of a registered RADIUS server, use the following command.
Command Mode Description
login radius server move
A.B.C.D <1-5>
Global
Specifies a priority of RADIUS server.
A.B.C.D: IP address
1-5: priority of RADIUS server
4.2.4.3 Timeout of Authentication Request
After an authentication request, the switch waits for a response from a RADIUS server for
specified time. To specify a timeout value, use the following command.
Command Mode Description
login radius timeout <1-100>
Specifies a timeout value.
1-100: timeout value for a response (default: 5)
no login radius timeout
Global
Deletes a specified timeout value.
4.2.4.4 Frequency of Retransmit
In case of no response from a RADIUS server, the switch is supposed to retransmit an
authentication request. To set the frequency of retransmitting an authentication request,
use the following command.
Command Mode Description
login radius retransmit <1-10>
Sets the frequency of retransmit.
1-10: frequency count (default: 3)
no login radius retransmit
Global
Deletes a specified frequency count.
i