Specifications

CLI Management Guide
TigerAccess™ EE
342 SMC7824M/VSW
To disconnect, input as the below.
SWITCH# exit
Connection closed by foreign host.
SWITCH(bridge)#
8.8 Rate Limit
User can customize port bandwidth according to user’s environment. By this configuration,
you can prevent a certain port to monopolize whole bandwidth so that all ports can use
bandwidth equally. Egress and ingress can be configured both to be same and to be dif-
ferent.
The switch can apply the rate limit with 64 Kbps unit for GE port, and support ingress po-
licing and egress shaping.
To set a port bandwidth, use the following command.
Command Mode Description
rate PORTS RATE [egress | in-
gress
]
Sets port bandwidth. If you input egress or ingress, you
can configure outgoing packet or incoming packet. The
unit is 64 Kbps.
RATE:64-1,000,000
no rate PORTS [egress | ingress]
Bridge
Clears rate configuration of a specific port by transmit-
ting direction.
For the ingress rate limit, the flow control should be enabled on a specified port! For more
information of the flow control, see Section
5.2.5.
To display a configured rate limit, use the following command.
Command Mode Description
show rate
Enable
Global
Bridge
Shows a configured rate limit.
!