Specifications

CLI Management Guide
TigerAccess™ EE
30 SMC7824M/VSW
Tab. 3.8 shows main commands of Interface Configuration mode.
Command Description
description Specifies a description.
ip address Assigns IP address.
shutdown Deactivates an interface.
mtu Sets MTU value.
Tab. 3.8 Main Command of Interface Configuration Mode
3.1.9 Rule Configuration Mode
The switch modifies previous Rule Configuration mode to Flow, Policer and Policy Con-
figuration modes. Rule configuration mode is expanded into three different modes accord-
ing to its roles for Rule mechanism. You can configure a rule for incoming or outgoing
packets. Using the function, you can handle packets classified by the rule.
To open Rule Configuration mode, enter the flow, policer and policy commands, then
the system prompt will be changed from SWITCH(config)# to SWITCH(config-
flow[NAME])#, SWITCH(config-policer[NAME])# and SWITCH(config-policy[NAME])# .
Command Mode Description
flow NAME create Opens Flow Configuration mode.
policer NAME create Opens Policer Configuration mode.
policy NAME create
Global
Opens Policy Configuration mode.
Tab. 3.9 shows the commands of Rule Configuration mode.
Command Description
cos Classifies an IEEE 802.1p priority.
mac Classifies a MAC address.
action match Configures a rule action for classified packets.
rate-limit Comfigures a rate-limit of classified packets
priority Configures a rule priority of specified policy.
Tab. 3.9 The Commands of Rule Configuration Mode
3.1.10 RMON Configuration Mode
In RMON Configuration mode, you can configure RMON alarm, RMON event and RMON
history. The switch provides three different configuration modes to configure each type of
RMON.
Command Mode Description
rmon-alarm <1-65535>
rmon-event <1-65535>
rmon-history <1-65535>
Global
Opens RMON Configuration mode.
1-65535: index number