Specifications

CLI Management Guide
TigerAccess™ EE
298 SMC7824M/VSW
To return the configured learning disable time as default, use the following command.
Command Mode Description
no erp domain DOMAIN-ID learn-
ing-disable-time
Bridge Configures ERP learning disable time as default value.
8.4.10 Test Packet Interval
RM Node periodically sends “RM Test Packet” message to detect the loop. To configure
an interval to send Test Packet message of RM node, use the following command.
Command Mode Description
erp domain DOMAIN-ID test-
packet-interval
<10-500>
Bridge
Specifies the interval of ERP test packet.
10-500: packet interval (unit: millisecond)
To delete the specified interval of ERP test packet interval, use the following command.
Command Mode Description
no erp domain DOMAIN-ID test-
packet-interval
Bridge Deletes the specified interval of ERP test packet.
8.4.11 LOTP Hold Off Time
It is necessary to prevent lower priority rings to trigger protection because of loss of test
packets before the protection of the higher priority ring and transmission of test packets
over this ring.
LOTP hold-off time determines the hold-off time for ERP switching in case of detection of
LOTP. This parameter provides independence between ERP rings. Hold-off time for LOTP
triggered ERP delays ERP switching if a ring protection of this domain is also provided by
other higher priority rings. LOTP Hold-Off Time value depends on the ring priority of ERP
rings.
To specify LOTP hold-off time, use the following command.
Command Mode Description
erp domain DOMAIN-ID hold-off-
time
<1-20000>
Bridge
Configures LOTP hold-off time
1-20000: ERP hold-off time (default: 0 ms, unit: milli-
second)
To configure LOTP hold-off time as default, use the following command.
Command Mode Description
no erp domain DOMAIN-ID hold-
off-time
Bridge Configures LOTP hold-off time as default value