Specifications

Management Guide CLI
TigerAccess™ EE
SMC7824M/VSW 271
To configure all ports as edge ports globally, use the following command.
Command Mode Description
spanning-tree edgeport default
Configures all ports as edge ports:
PORTS: port number.
no spanning-tree edgeport de-
fault
Bridge
Deleted a configured edge ports for all ports. (default)
To configure a specified port as edge port, use the following command.
Command Mode Description
spanning-tree port PORTS edgeport enable
Configures specified port as edge port.
PORTS: port number.
spanning-tree port PORTS edgeport disable
Bridge
Disables edge port for specified port.
PORTS: port number
8.3.6.3 BPDU Transmit hold count
You can configure the BPDU burst size by changing the transmit hold count value. To
configure the transmit hold-count, use the following command.
Command Mode Description
spanning-tree transmit hold-
count
<0-20>
Sets the number of BPDUs that can be sent before
pausing for 1 second:
0-20: BPDU transmit hold-count value (default:6)
no spanning-tree transmit hold-
count
Bridge
Deletes a configured transmit hold-count value and
returns to the default setting.
If you change this parameter to a higher value can have a significant impact on CPU utili-
zation, especially in Rapid-PVST mode. We recommend that you maintain the default set-
ting.
8.3.6.4 Port Priority
When all conditions of two switches are same, the last standard to decide route is port-
priority. It is also possible to configure port priority so that user can configure route manu-
ally. To configure the port-priority, use the following command.
Command Mode Description
spanning-tree port PORTS port-
priority
<0-240>
Configures port priority.
PORTS: port number
0-240: port priority in increments of 16 (default:128)
no spanning-tree port PORTS
port-priority
Bridge
Deleted a configured port priority.
!