Specifications

Management Guide CLI
TigerAccess™ EE
SMC7824M/VSW 253
LACP can generate up to 5 aggregators whose number value could be 0 to 4. The group
ID of trunk port and the aggregator number of LACP cannot be configured with the same
value.
The following explains how to configure LACP.
•
Configuring LACP
•
Operation Mode
•
Priority of Switch
•
Manual Aggregation
•
BPDU Transmission Rate
•
Administrational Key
•
Port Priority
•
Displaying LACP Configuration
8.2.2.1 Configuring LACP
Step 1
Activate LACP function, using the following command.
Command Mode Description
lacp aggregator AGGREGA-
TIONS
Bridge
Enables LACP of designated Aggregator-number:
AGGREGATIONS: select aggregator ID that should be
enabled for LACP (valid value from 0 to 4).
Step 2
Configure the physical port that is a member of aggregated port. To configure the member
port, use the following command.
Command Mode Description
lacp port PORTS Bridge
Configures physical port that is member port of aggre-
gator; select the port number(s) that should be enabled
for LACP.
To disable LACP and delete the configuration of LACP, use the following command.
Command Mode Description
no lacp aggregator AGGREGA-
TIONS
Disables LACP for designated Aggregator-number,
select the aggregator ID that should be disabled for
LACP.
no lacp port PORTS
Bridge
Deletes member port of Aggregator, select the port
number(s) that should be disabled for LACP.
i