Specifications

Management Guide CLI
TigerAccess™ EE
SMC7824M/VSW 233
To give an owner name of receiver, use the following command.
Command Mode Description
owner NAME Gives an owner name of specific receiver.
no owner
Receiver
Deletes the owner name.
7.16.7.5 Timeout
To set a timeout of receiver, use the following command.
Command Mode Description
timeout <1-2147483647>
Sets a timeout of receiver.
1-2147483647: timeout value (default:0)
no timeout
Receiver
Deletes configured timeout of receiver.
7.16.8 Receiver Index
If you configure one receiver when sFlow function of specific port was already enabled in
the system, you should assign the configured receiver index of that port for transmitting
sampling packets to sFlow collector
To specify configured receiver index to port, use the following command.
Command Mode Description
sflow port PORTS receiver-
index <1-65535>
Specifies a receiver index of port to transmit sampling
packets to sFlow collector.
1-65535: receiver ID
no sflow port PORTS receiver-
index
Global
Deletes specified receiver index of port.
7.16.9 Displaying sFlow
To display the current status of sFlow service, agent IP address, receiver ID and so on,
use the following command.
Command Mode Description
show sflow
Enable
Global
Shows the information of sFlow.