Specifications

CLI Management Guide
TigerAccess™ EE
166 SMC7824M/VSW
7.5.3 Syslog Bind Address
You can specify an IP address to attach to the syslog message for its identity. To specify
the IP address to bind to a syslog message, use the following command.
Command Mode Description
syslog bind-address A.B.C.D Specifies the IP address to bind to a syslog message.
no syslog bind-address
Global
Deletes a specified IP address.
7.5.4 Debug Message for Remote Terminal
To display a syslog debug message to a remote terminal, use the following command.
Command Mode Description
terminal monitor Enables the terminal monitor function.
no terminal monitor
Enable
Disables the terminal monitor function.
7.5.5 Disabling Syslog
To disable the syslog, use the following command.
Command Mode Description
no syslog Global Disables the syslog.
The syslog is basically enabled in the system.
7.5.6 Displaying Syslog Message
To display the received syslog message in the system memory, use the following com-
mand.
Command Mode Description
show syslog local {volatile |
non-volatile} [NUMBER]
Shows the received syslog messages.
volatile: removes the syslog messages after restart.
non-volatile: reserves the syslog messages.
NUMBER: shows the last N syslog messages.
show syslog local {volatile |
non-volatile} reverse
Shows the received syslog messages in the reverse
order.
show syslog {volatile | non-
volatile} information
Shows the usage of the area where the received sys-
log messages are stored.
clear syslog local {volatile | non-
volatile}
Enable
Global
Bridge
Removes the received syslog messages.
i