Specifications

CLI Management Guide
TigerAccess™ EE
156 SMC7824M/VSW
Input a question mark <?> at the system prompt in RMON Configuration mode if you
want to list available commands.
The following is an example of listing available commands in RMON Configuration mode.
SWITCH(config-rmonhistory[5])# ?
RMON history configuration commands:
active Activate the history
data-source Set data source name for the ethernet port
do To run exec commands in config mode
exit End current mode and down to previous mode
help Description of the interactive help system
interval Define the time interval for the history
owner Assign the owner who define and is using the history
resources
requested-buckets Define the bucket count for the interval
show Show running system information
write Write running configuration to memory or terminal
SWITCH(config-rmonhistory[5])#
7.4.1.1 Source Port of Statistical Data
To specify a source port of statistical data, use the following command.
Command Mode Description
data-source NAME RMON
Specifies a data object ID:
NAME: enters a data object ID. (ex. ifindex.n1/port1)
7.4.1.2 Subject of RMON History
To identify a subject using RMON history, use the following command.
Command Mode Description
owner NAME RMON
Identifies subject using relevant data, enter the name
(max. 32 characters).
7.4.1.3 Number of Sample Data
To configure the number of sample data of RMON history, use the following command.
Command Mode Description
requested-buckets <1-65535> RMON
Defines a bucket count for the interval, enter the num-
ber of buckets.
1-65535: bucket number (default: 50)