Specifications

Management Guide CLI
TigerAccess™ EE
SMC7824M/VSW 139
To display a granted SNMP group to access to a specific SNMP view record, use the fol-
lowing command.
Command Mode Description
show snmp access
Enable
Global
Bridge
Shows a granted SNMP group to access to a specific
SNMP view record.
7.1.7 SNMP Version 3 User
In SNMP version 3, you can register an SNMP agent as user. If you register an SNMP
version 3 user, you should configure it with the authentication key. To create/delete an
SNMP version 3 user, use the following command.
Command Mode Description
snmp user USER {md5 | sha}
AUTH_KEY [des PRIVATE_KEY]
Creates an SNMP version 3 user.
no snmp user USER
Global
Deletes a registered SNMP version 3 user.
To display a current SNMP version 3 user, use the following command.
Command Mode Description
show snmp user
Enable
Global
Bridge
Displays an SNMP version 3 user.
7.1.8 SNMP Trap
SNMP trap is an alert message that SNMP agent notifies SNMP manager about certain
problems. If you configure the SNMP trap, the system transmits pertinent information to
network management program. In this case, trap message receivers are called a trap
host.
7.1.8.1 SNMP Trap Mode
To select the SNMP trap mode, use the following command.
Command Mode Description
snmp trap-mode {alarm-report |
event}
Global
Selects the SNMP trap mode.
alarm-report: alarm report based trap
event: event based trap (default)
“event” trap-mode is set by default. It generates event based traps.
“alarm-report” trap-mode generates alarm report based traps.
If you manage the system via the ACI-E, you should set the SNMP trap mode to the
alarm-report.
!