Specifications

Management Guide CLI
TigerAccess™ EE
SMC7824M/VSW 121
6.1.13.6 SFP Module (optional uplink port)
The system module will operate depending on monitoring type of temperaturem, RX/TX
power, voltage or Txbias. To set the threshold of module, use the following command.
Command Mode Description
threshold module {rxpower |
txpower} {alarm | warning}
PORTS START-VALUE STOP-
VALUE
Sets the Diagnostics threshold of SFP module by
RX/TX power and monitors the module
The range of RX/TX power: 0-6.5535 ㎽
threshold module temper {alarm
| warning} PORTS START-TEMP
STOP-TEMP
Sets the Diagnostics threshold of SFP module depend-
ing on temperature and monitors the module
The range of temperature: -128∼127.99℃
threshold module txbias {alarm |
warning} PORTS
Sets the Diagnostics threshold of SFP module depend-
ing on txbias and monitors the module.
The range of txbias: 0- 131 ㎖
threshold module voltage {alarm
| warning} PORTS
Global
Sets the Diagnostics threshold of SFP module depend-
ing on voltage and monitors the module
The range of voltage: 0-6.5535 V
To delete the threshld of module operation depending on specified monitoring type, use
the following command.
Command Mode Description
no threshold module {rxpower |
voltage | txbias | txpower | tem-
per} {alarm | warning} PORTS
Global Deletes the configured threshold of SFP module.
To display the configuration of SFP module of specific port, use the following command.
Command Mode Description
show port module-info [PORTS]
Enable
Global
Bridge
Displays the status of SFP module.
If you insert an SFP module including Diagnostic Monitoring Interface (DMI) into ports,
you can see the real-time information about the ports such as transceiver type, length,
connector type, and vendor information of the SFP. However, you might not want to see
DMI polling information because it may result in CPU overload to collect DMI data via I
2
C
interface.
To enable or disable collecting DMI information from SFP mouldes, use the following
command.
Command Mode Description
module dmi {enable | disable} Global
Specifies whether to collect DMI information from SFP
modules.