Specifications

Management Guide CLI
TigerAccess™ EE
SMC7824M/VSW 119
To show the configured threshold of CPU load, use the following command.
Command Mode Description
show cpuload Shows the configured threshold of CPU load.
show cpu-trueload
Enable
Global
Bridge
Shows the CPU usage every 5 seconds during current
10 minutes.
6.1.13.2 Port Traffic
To set the threshold of port traffic, use the following command.
Command Mode Description
threshold port PORTS
THRESHOLD {5 | 60 | 600} {rx |
tx}
Sets the threshold of port traffic.
PORTS: port number
THRESHOLD: threshold value (unit: kbps)
5 | 60 | 600: time interval (unit: second)
no threshold port PORTS {rx |
tx}
Global
Deletes the configured threshold of port traffic.
The threshold of the port is set to the maximum rate of the port as a default.
To set a timer to block incoming traffic through specific port, use the following command.
Command Mode Description
threshold port PORTS block
timer <10-3600>
Set a timer to block the traffic which goes over its
threshold.
10-3600: expire timer (unit: second)
no threshold port PORTS block
Global
Deletes the configured threshold of port traffic.
To show the configured threshold of port traffic, use the following command.
Command Mode Description
show port threshold Enable/Global/Bridge
Shows the configured threshold of port
traffic.
6.1.13.3 Fan Operation
The system fan will operate depending on measured system temperature. To set the
threshold of fan operation, use the following command.
Command Mode Description
threshold fan START-TEMP
STOP-TEMP
Sets the threshold of fan operation in the unit of Cel-
sius (°C).
START-TEMP: starts fan operation. (default: 30)
STOP-TEMP: stops fan operation. (default: 0)
no threshold fan
Global
Deletes a configured threshold of fan operation.
i