Specifications

Management Guide CLI
TigerAccess™ EE
SMC7824M/VSW 107
To designate AGC and configure it manually, you should designate the distance. To dis-
able the configured AGC, use the following command.
Command Mode Description
cpe {agc-off-0ㅣagc-off-1ㅣagc-off-2ㅣagc-off-3ㅣ
agc-off-4ㅣagc-off-5ㅣagc-off-6ㅣagc-off-7ㅣagc-
off-8ㅣagc-off-9ㅣagc-off-10} PORTS
Bridge
Disable AGC in CPE and configure the
distance manually.
There can be some error in manually designated distance.
5.3.5.5 Checking Length of Cable between CPE and CO
To check cable length from CO to CPE, use the following command.
Command Mode Description
show lre ewl PORTS Enable/Global/Bridge Checks cable length from CO to CPE
5.3.5.6 Auto-negotiation of CPE
To enable or disable the auto negotiation of CPE Ethernet port, use the following com-
mand.
Command Mode Description
cpe nego PORTS on
Enables the auto-negotiation on CPE ethernet port.
(default: on)
cpe nego PORTS off
Bridge
Disables the auto-negotiation CPE ethernet port
5.3.5.7 Transmit Rate of CPE
To set the transmit rate of an Ethernet port of CPE, use the following command.
Command Mode Description
cpe speed PORTS {10 | 100} Bridge
Sets the transmit rate of the CPE ethernet port to
10/100 Mbps,
5.3.5.8 Duplex mode of CPE
To set the duplex mode on an Ethernet port of CPE, use the following command.
Command Mode Description
cpe duplex PORTS {full | half} Bridge
Sets full-duplex or half-duplex mode on Ethernet port of
CPE.
i