Operation Manual

9
Gear lever
The gear change pedal –1– located near the left foot rest
is of the progressive shift, positive stop type, which means
one full stroke of the gear change pedal will shift only gear
position. The shifting sequence is arranged as shown in
the figure.
1 The gear change pedal
Shifting from the neutral position into 1st gear (low gear)
is performed by pressing the front end of the gear change
pedal with the toe. Shifting to 2nd and 3rd is performed by
progressively pressing the forward end of the pedal. Shifting
down to the lower gears is performed by progressively
pressing the rear end of the pedal. The transmissions
neutral position is located above 1st gear.
NOTE:
DURING ALL NORMAL GEAR CHANGES, THE THROTTLE MUST
BE MOMENTARILY CLOSED TO AVIOD EXCESSIVE ENGINE
R.P.M. AND UNDUE STRESS ON DRIVE TRAIN COMPONENTS.
SHIFT UP
SHIFT DOWN
Choke lever
The choke lever –1– is located at the left side of the
carburetor. When the choke lever is up, the choke valve is
fully open. (cold engine starting position). When the choke
lever is down, the choke is fully closed.
1 The choke lever
shift up shift up
gear shift sequence
N
1
2
3
Air filter
The air filter –2– is located in the middle of frame, assures
that only clean air enters the cylinder
2 The air filter box